Electronics Forum | Thu Jul 26 13:49:48 EDT 2001 | johnmaetta
That's a good question. On some of the assemblies that our engineers test, appear to have been reworked in these suspect locations. I have requested rework data from our CM by providing them with assembly and serial numbers. Their data shows that th
Electronics Forum | Thu Jul 26 14:06:46 EDT 2001 | johnmaetta
That's a good question. On some of the assemblies that our engineers test, appear to have been reworked in these suspect locations. I have requested rework data from our CM by providing them with assembly and serial numbers. Their data shows that th
Electronics Forum | Thu Jun 12 00:32:23 EDT 2003 | Henry
I would like to ask a question about SMT reflow process. I did 10 pcs samples but all is fail. The sample is double faces to have components (up-side has 4 pcs of BGA and down-side has 3 BGA and 2 QFP). And I saw some of BGA which is tilting in the P
Electronics Forum | Thu Jun 12 03:34:23 EDT 2003 | sanjeevc
I would like to ask a question about SMT reflow > process. I did 10 pcs samples but all is fail. > The sample is double faces to have components > (up-side has 4 pcs of BGA and down-side has 3 BGA > and 2 QFP). And I saw some of BGA which is > t
Electronics Forum | Wed Jul 16 18:21:20 EDT 2008 | emti
BGA Placement is not easy as we think, Mainly you have to make sure you don't have acceessive amount of paste, try to paste your board as it covers full ball, make sure it is not short before you place any part. If you placing the BGA by hand be car
Electronics Forum | Thu Jul 26 22:52:47 EDT 2001 | davef
GT 8 years ago every board saw "touchup". Touch was done to fix boards to conform to A-610. Now A-610 allows less than complete hole fill. Our operators were totally freaking nuts about touching boards. They touched each others touch and on and o
Electronics Forum | Tue Jul 24 19:26:20 EDT 2001 | johnmaetta
Thanks Dave. We develop high-speed telecom PCB assemblies that use uBGA and other fine pitch components. Our policy has been to use an NC process at our CM. Our engineering group, who is also a customer, and uses these assemblies for development,
Electronics Forum | Thu Jun 07 05:11:42 EDT 2012 | cp38260
Hi, I have pcbs (Duroid/RT 5880) with raw copper, soldered in vapour-phase chamber at 230 degrees Celsius. During soldering, copper gets tarnished. Cleaning with Vigon A250 removes the tarnished layer. Indeed, in the VigonA250 techn. datasheet it is
Electronics Forum | Thu Jul 12 02:15:53 EDT 2012 | thmeier
Check also the specs / recommendations of your PCB manufacturer. We bake boards 4h/120°C before reflow and after automated cleaning (it´s not FR4!) and also if we have to rework with the autometd rework- stations (massive IR underheating ,..). Regar
Electronics Forum | Wed Aug 04 11:27:53 EDT 1999 | M. Wolf
I need to find quality benchtop develop, strip, & etch equipment. Any ideas?
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
