Electronics Forum | Tue Nov 04 10:02:21 EST 2008 | m79d
jerry this is what i wanted to hear 'real' measurements. I did not want to make the tooling strip too wide as that would add to the cost of the bare board. thank mickd
Electronics Forum | Wed Oct 18 07:51:14 EDT 2006 | davef
Look here: http://www.circuittechctr.com/ As a low cost approach, use copper foil purchased from a stained glass window hobbyist shop. Cut foil pieces to size with a sharp knife. Epoxy the pieces in place of the damaged pads. Tin and then solder th
Electronics Forum | Fri Jul 27 10:07:18 EDT 2007 | rgduval
Our preference has been ENIG. We find that we achieve higher quality (visually) soldering for through hole and surface mount parts, with less handling issues than when we use white-tin, or immersion tin. We are about to do a test on some boards tha
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Mon Oct 16 17:46:49 EDT 2006 | Dan
Recently I was given a bad Bios Link from Toshiba which fried my Bios and now my laptop boots to a black screen. I recently unsoldered and removed the existing Bios chip and have ordered anotherfor replacement. Unfortunately while removing, i damag
Electronics Forum | Mon Aug 11 04:08:52 EDT 2008 | janet200701
we want to estimate the price of assemblyng a > board that contain both SMD and THT component . > and also we have the BOM file of this board . > please help me There is 3part on the cost: 1. PCB cost 2.Assembly cost 3.components cost. If you w
Electronics Forum | Tue Aug 12 19:18:34 EDT 2008 | arminski
Hi davef, couple of questions: clarifying costing of direct labor against overhead cost: an operator loading PCB onto the reflow oven is a direct cost, how about the reflow process time of the PCB while travelling inside the reflow, is that an ove
Electronics Forum | Mon Aug 27 11:11:16 EDT 2012 | rway
We have 1/2 dozens 0.031 pcbs that bow after going through the oven. We are looking for a solution to this problem to prevent bowing of the pcbs. As a result of the bowing, the pcbs, on occasion get caught in the oven, and more often have transfer
Electronics Forum | Mon May 04 06:31:50 EDT 2020 | jandon
Are you capable of doing Class 3 products? Does the design, bare PCB board and assembly meet the requirements of Class 3?
Electronics Forum | Tue May 05 07:04:25 EDT 2015 | anirudh_thabjul
Hi Everyone, I have done with my PCB Prototyping. I want to send my Bare Board for Components assembly. So, I need to order the respective components for my assembly. Can anyone suggust me a good electronic distributor in France or Europe. Re
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
