Electronics Forum | Fri May 18 12:21:28 EDT 2001 | camohn
When it comes to how much epoxy [aka. "glue"] to dispense to hold a IC or any part with significant mass, on the bottom of a board for wave soldering, is more better? The way I see it, one good dot should be holding such a part on the PCB. If not, th
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Fri Aug 06 03:51:06 EDT 1999 | Thomas
Could someone give recommendation on the stencil opening for printing epoxy on HAL FR4 PCB for 0805 and 0603 size chips capacitors and resisitors. My regular stencil manufacturer recommend the following: Thickness: 8 mils 0805 opening: Oblong 0.35 X
Electronics Forum | Sat Aug 07 11:10:03 EDT 1999 | JohnW
| Could someone give recommendation on the stencil opening for printing epoxy on HAL FR4 PCB for 0805 and 0603 size chips capacitors and resisitors. | My regular stencil manufacturer recommend the following: | Thickness: 8 mils | 0805 opening: Oblong
Electronics Forum | Wed Dec 06 21:59:37 EST 2006 | SMTrework
Hello, we rework BGA packages that come back from the field. I've seen on occasion a black and or red "epoxy" substance from the manufacturer on the corner of some board's BGA chips that I imagine are applied to increase corner bond of the chip to th
Electronics Forum | Tue Jan 31 12:19:29 EST 2017 | ttheis
We're looking to add conformal coating to some of our pcb's which range from 2x2" to around 6x6". I would like to use a coating material that is not nasty smelling requiring ventilation or filtration if possible. Are there conformal materials that ar
Electronics Forum | Wed Dec 06 22:46:39 EST 2006 | SMTrework
Hi Dave, This is manufacturer applied epoxy / adhesive to minimize package "lifing" from chassis flexing and thius board flexing. I have seen the complete array area covered with this black or red epoxy in some cases (i.e. the underfill that I've
Electronics Forum | hhudson |
Sat Jan 27 17:31:29 EST 2024
Electronics Forum | Wed Oct 18 07:51:14 EDT 2006 | davef
Look here: http://www.circuittechctr.com/ As a low cost approach, use copper foil purchased from a stained glass window hobbyist shop. Cut foil pieces to size with a sharp knife. Epoxy the pieces in place of the damaged pads. Tin and then solder th
Electronics Forum | Mon Jul 12 11:11:25 EDT 2004 | Stefan
For laser marking you don�t require as powerful lasers then for cutting. A 20 Watt laser diode does already a good job. Because of the safety requirements the laser operates in an enclosure, which means more $$$ if you want to use the laser in line
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
