Electronics Forum | Sat Aug 05 08:08:35 EDT 2006 | rogerw_tech
hi everyone I am doing a research on pcb manufacturing I like to know the process that takes palce in a manufacturing company including the machinery and equipments being used I did a lot searching on the internet but I did not find what I want. t
Electronics Forum | Tue May 15 12:14:25 EDT 2001 | brownsj
If the boards are pre-scored, I've used a system called the CAB Maestro which I found to be a very cost effect piece of equipment. www.cabtechn.com Steve.
Electronics Forum | Fri May 11 17:21:04 EDT 2001 | davef
Three main groups of depaneling equipment are: 1 Scoring: Limited to straight edges and mainly 90� angles 2 Routing: And a cloud of dust 3 Singulating: Hard tooled by board To get started understanding the suppliers look here: http://www.cassembly.c
Electronics Forum | Fri Jul 28 19:55:31 EDT 2006 | scott
I would agree for a bare board house, are you NUTS? Look what happend to McCurdey's high tech line in S. Cal., go chewed up and spit out by China... Plating, etching, environmental issues, regulations, lack of people who like doing that work... endle
Electronics Forum | Wed Aug 04 11:27:53 EDT 1999 | M. Wolf
I need to find quality benchtop develop, strip, & etch equipment. Any ideas?
Electronics Forum | Wed Aug 04 17:12:08 EDT 1999 | John Thorup
| I need to find quality benchtop develop, strip, & etch equipment. | Any ideas? try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement John Thorup
Electronics Forum | Wed Aug 04 17:21:59 EDT 1999 | John Thorup
| | I need to find quality benchtop develop, strip, & etch equipment. | | Any ideas? | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | John Thorup | let's try that link again
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Wed Dec 03 06:04:10 EST 2014 | spoiltforchoice
Manual placement aids are often very similar, I would suggest it is quite difficult to tell them all apart. Most of them include some kind of carousel for bins of loose parts and have the option of a few tape "feeders". If you are building small volu
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
