Electronics Forum | Thu Nov 16 06:13:16 EST 2000 | Adam Seychell
I am currently building a home PCB etching tank based on the ammonia/ammonium sulfate chemistry. The etching system consists of a etching tank, and an electrolytic copper recovery tank. The result is a infinitely replenishable etching system without
Electronics Forum | Mon Jul 26 17:57:50 EDT 2021 | cyber_wolf
Place a label and etch that instead of the PCB. Too many variances in solder mask
Electronics Forum | Fri Jul 28 19:55:31 EDT 2006 | scott
I would agree for a bare board house, are you NUTS? Look what happend to McCurdey's high tech line in S. Cal., go chewed up and spit out by China... Plating, etching, environmental issues, regulations, lack of people who like doing that work... endle
Electronics Forum | Mon Jul 21 22:37:07 EDT 2014 | acdc
Check out Control Micro Systems based out of Florida. They are solely dedicated to pcb laser etching.
Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Wed Aug 04 11:27:53 EDT 1999 | M. Wolf
I need to find quality benchtop develop, strip, & etch equipment. Any ideas?
Electronics Forum | Wed Aug 04 17:12:08 EDT 1999 | John Thorup
| I need to find quality benchtop develop, strip, & etch equipment. | Any ideas? try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement John Thorup
Electronics Forum | Wed Aug 04 17:21:59 EDT 1999 | John Thorup
| | I need to find quality benchtop develop, strip, & etch equipment. | | Any ideas? | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | John Thorup | let's try that link again
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
