Electronics Forum | Fri Jul 23 14:07:52 EDT 1999 | Carl J. Odle
We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after a p
Electronics Forum | Sun Jul 25 08:54:37 EDT 1999 | Tom Gervascio
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Fri Jul 30 09:43:44 EDT 1999 | C.K.
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Thu Feb 13 10:38:51 EST 2003 | davef
Given that you are bridging front to back, contast the situation with the thiefs used to prevent bridging when wave soldering SOIC. If this is reasonable, the thiefs should be located behind the trailing connector pins. You can prove-out this [and
Electronics Forum | Thu Dec 04 14:31:59 EST 2003 | irun
Hallo We are going to clean PCb after assembly (SMD and THT) due to conformal coating. It is small value production with elements on PCB like BGA, QFP. What you recommend or suggest to use : ultrasonic? , spray wash? or something like dish wash???.
Electronics Forum | Thu Jul 17 20:20:21 EDT 2014 | mac5
Hi June, The biggest issue with an OSP finish is as soon as the PCB sees a heat cycle (reflow or wave) the finish will begin to degrade. If you have a single sided SMT assembly with THT components installed downstream it works pretty good. But a dou
Electronics Forum | Sun May 07 07:25:54 EDT 2006 | dismon
Dismon Electronica S.L. is situated in Spain and dedicates to PCB assembling both SMT and THT. You can visit http://www.dismon-electronica.com and contact us if this is of your interest.
Electronics Forum | Mon Feb 25 06:23:15 EST 2008 | smtnet51
We also used color coding of bins, along with a picture of where to put the part on the PCB. Also split up parts that look similar (to seperate work stations) when possible. good luck
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)