Electronics Forum | Fri Feb 05 09:22:25 EST 1999 | Dave F
| | | Joni: What is it about your situation with the board/component/process that makes you want to explore alternatives? Dave F | | Dave: In our case the component is placed on metalled footprint which has via holes to transfer the heat via hole
Electronics Forum | Fri Aug 17 01:40:55 EDT 2001 | V.RAMANAND KINI
We are in the watch & clock Business. We have a Watch IC chip that has to be wirebonded using Ultrasonic aluminium wedge bonder. The wire dia is 1.25mil. The PCB is made of G10 Glass epoxy copper clad laminate. The copper thickness is 18 microns. The
Electronics Forum | Tue Mar 21 20:25:30 EST 2000 | Dave F
John: What�s the matter? Free gold � good thing for you, bad thing for your supplier. :^) Pre-tinning of gold plated leads is important to: � Prevent gold embrittlement of the solder joint � Determine if the leads are solderable prior to assembly (
Electronics Forum | Tue Aug 11 07:51:57 EDT 1998 | Earl Moon
| | | | Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated, n
Electronics Forum | Mon Aug 10 21:52:34 EDT 1998 | Dave F
| | | Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated, not
Electronics Forum | Wed Aug 12 07:22:52 EDT 1998 | Earl Moon
| | | | | Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated,
Electronics Forum | Thu Jan 14 23:38:34 EST 1999 | Chris G.
| I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some con
Electronics Forum | Tue Mar 31 05:26:14 EDT 2009 | d0min0
Hello, we had similar problem in the past - when we had to change PCB supplier from a batch of hundreds of boards (NiAu plated, SnPb process) we got 2-3 boards with paste wicking to components leads what we did, was to check the thickness of gold on
Electronics Forum | Wed Jan 11 10:08:28 EST 2006 | muse95
This was the test method mentioned to me about 5 years ago, to use for testing for black pad, when we were evaluating the use of gold immersion for the first time. It is not practical for testing the entire surface of a PCB, but it should work well
Electronics Forum | Fri Jan 15 11:40:37 EST 1999 | Bob Willis
| | I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some c
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
