Electronics Forum | Sun Nov 01 23:34:25 EST 2009 | 89jeong
Hello Julie Yr supplier is saying that these boards meet the requirement of IPC-A-610. I think that you need to check this requirements at least. But, it does dot mean that these are acceptable. Thanks.
Electronics Forum | Mon Nov 02 22:02:01 EST 2009 | boardhouse
Umar - the boards are not assembled - so Solder splash is not applicable. Solder resist does not Melt it cures. As a board supplier I would not want my clients to adapt if they are receiving crap product, I would expect them to leave.
Electronics Forum | Tue Oct 27 22:52:18 EDT 2009 | davef
Top picture: We're not wild about the 'poor registration,' the differing thickness of the solder mask, and the crud all over the board. But, then again, we don't have a basis for rejection. Bottom picture: No basis for rejection Help us out, what do
Electronics Forum | Wed Oct 28 07:26:19 EDT 2009 | julie331975
I don't like these boards for a couple different reasons. 1. They may be fine functionally but they look like crap. 2. What is our customer going to think when we deliver boards that look like this? They will probably wonder the same thing I do...
Electronics Forum | Thu Oct 29 18:33:18 EDT 2009 | comatose
The top picture probably won't run. You have black soldermask dramatically misregistered and overlapping what look a lot like fids. Either your machines are going to pitch a fit and not find the fid or they're going to center on the soldermask outlin
Electronics Forum | Mon Nov 02 07:16:47 EST 2009 | umar
Base on the top picture condition, seems like the boards condition is a lot with solder splash or solder ball which is per IPC-610 is under reject (under 5.6.2)for class 3 product. While the picture 2 is showing those the solder resist is not melt pr
Electronics Forum | Tue Nov 03 18:09:17 EST 2009 | gregoryyork
I think most have summed up the first pictures also is the drillng looking like it is misregistered as well. Better to do a solvent test to determine resist cure not the old stuff the newer chemicals show under cure problem much better. Try your st
Electronics Forum | Sun Nov 01 23:51:44 EST 2009 | boardhouse
Hi Julie, My opinion is that the top board would not pass IPC, solder mask encroachment on pads. Second board is what we call Orange peel,this can be caused two way's. 1) the solder mask was not tack dried enough prior to imaging which caused artwo
Electronics Forum | Tue Nov 03 20:00:47 EST 2009 | davef
Solder Mask Adhesion Pull Test Tape List IPC-TM-650 Test Method 2.4.28.1, Adhesion, Solder Resist (Mask), Tape Test Method, defines the procedure for determining the adhesion of solder resists (masks) used over melting metals, (such as solder plated
Electronics Forum | Mon Dec 10 03:51:03 EST 2012 | odedkal
Hello, I work in a company in Israel that among other things, design and produce pallettes for flex pcb's. Plaese see our page if it is still relevant. http://www.aradmetal-p.com/arad_home Thank you
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
.jpg)