Electronics Forum | Mon Mar 16 18:39:48 EST 1998 | Rin Or
Hi all, I would like to have some information regarding the paste in holes process.We are the Backplane manufacturing and dealing with lots of thick PCB and would like to change the processes from wave to paste in hole.Any feed back of info or exper
Electronics Forum | Tue Jun 04 14:14:42 EDT 2002 | ckd
I meant to include this in the original message. One, the solder balls are on the circuit side of PCB. Two, some of the vias on both top and bottom are closed and some are not. Is this a process problem with the board house(s)?
Electronics Forum | Mon Aug 12 16:54:37 EDT 2002 | sasharm2
We are getting broken traces in PCBAs, any idea why. In addition, only few of the boards show this problem, hence I don't think it is an issue with the board manufacturer. thanks, SS
Electronics Forum | Mon Aug 12 18:44:50 EDT 2002 | dragonslayr
sounds like a couple of goofballs held an impromptu frisbee contest in your receiving inspection area. As likely a cause as any, given the limited information you supplied. Plus, you have already decided that it is not your fab house, so what can con
Electronics Forum | Mon Aug 12 22:11:23 EDT 2002 | davef
I agree with what those other guys said. You problem description is vague. Please describe: * 'Broken' trace appearance * Where it is located * Process steps up to discovery * Board design * etc.
Electronics Forum | Sat Oct 12 05:40:05 EDT 2002 | Kenture
Hello All, I am having issued with insufficient solder due to via in pad. It is a 10 mils via and PCB is 70 mil thick. Six mils stencils was used since there are some 20 mils (No clean process). Any recommendation? Thank you.
Electronics Forum | Wed Nov 10 02:13:32 EST 2004 | Grant
Hi, We are thinking about starting to use via in Pad, for both BGA and 0402 and 0201 components. Does anyone know how this would effect production. Obviously PCB production is not difficult, but this should only effect production and assembly. R
Electronics Forum | Sun May 07 07:25:54 EDT 2006 | dismon
Dismon Electronica S.L. is situated in Spain and dedicates to PCB assembling both SMT and THT. You can visit http://www.dismon-electronica.com and contact us if this is of your interest.
Electronics Forum | Tue May 16 19:51:58 EDT 2006 | davef
IPC [ipc.org] publishes this type of information for US markets. They might be able to give you a contact for the Ozzy market.
Electronics Forum | Fri Jul 13 04:58:01 EDT 2007 | pavel_murtishev
Good afternoon, Heating/Cooling rates contribute to warpage most of all. Try to tweak you profile so that heating/cooling rate would be minimized. Try to switch cooling blowers off maintaining required peak/TAL. Check copper balance for this PWB, by
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830