Electronics Forum | Tue Feb 28 19:46:07 EST 2006 | Rookie
We been having problem with raw PCB quality. Is there a procedure to inspect incoming material? What should we look for?
Electronics Forum | Tue Feb 28 20:56:12 EST 2006 | davef
Here you go ... PCB FR-4 Inspection Manual 1 Introduction This defines the minimum acceptability requirements. It is not intended for use as a performance specification for the Company or procurement. It is based on the requirements of Acceptabi
Electronics Forum | Sat Apr 25 07:10:01 EDT 1998 | JoSi
Hi, A collegue of mine, working on incoming inspection departement, asked me if I know any good standard,preferrable on CD-ROM with high-quality images of different defects that can be found on bare pcb`s. I know IPC-standards, but is there any
Electronics Forum | Sat Apr 25 09:13:26 EDT 1998 | Earl Moon
| Hi, | A collegue of mine, working on incoming inspection | departement, asked me if I know any good standard,preferrable | on CD-ROM with high-quality images of different defects | that can be found on bare pcb`s. | I know IPC-standards, but i
Electronics Forum | Tue Sep 01 17:44:46 EDT 2015 | abisson
Hello to All, Is someone can refer me to an IPC standard where the maximum allowance of pcb stretch is mention? I've look into IPC-600, or 2222 or 2615 and I cannot find what I'm looking for. I will like to implement a pass/fail incoming inspection
Electronics Forum | Wed Sep 02 20:18:18 EDT 2015 | sarason
Are your PCB's stretched or is it that the films that were used to make your PCB's distorted.Thus vias and TH's don't align. These things will probably be picked up in bare board testing , but depending on the amount of offset may get through, to yo
Electronics Forum | Tue Apr 15 08:38:23 EDT 2003 | pjc
Don't have any specific links to papers and articles. Try searching on the IPC.org (plus APEX show http://www.goapex.org) and SMTA.org web sites. Any papers and articles on the process from equipment mfg.'s should be taken with a grain of salt. Sold
Electronics Forum | Thu Apr 01 15:19:54 EDT 2010 | dilogic
We've got prototype 6-layer PCB's and I suspect that mfg. swapped some internal layers. Would it be possible to use some form of x-ray inspection to verify that? Any ideas?
Electronics Forum | Fri Sep 16 11:28:20 EDT 2011 | dwanzek
I am looking for input on good blacklight to inspect silicon coating coverage on PCB's. This inspection is visual. Any advice or recommendations on lamps or bulbs?
Electronics Forum | Tue Nov 30 11:08:22 EST 2004 | jdumont
Hey all, we will be starting to coat our PCB's soon. I am looking for info on what type of UV light is needed to inspect the boards. We will be using Humiseal 1B73 Acrylic coating. TIA, JD
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830