Electronics Forum | Wed Feb 06 08:36:34 EST 2013 | leigh
We have used a OK International APR-5000-XLS for the past 5 years, and have never had any issues with it. It works great on all types of BGA's and PCB's. There is sufficient heating topside and bottom, you can hook up thermocouples and fine tune yo
Electronics Forum | Fri Apr 26 05:43:50 EDT 2019 | ppcbs
Check out our line of Shuttle Star BGA Rework Stations. Our model SV550 is $18,500.00 installed. Installation includes training on machine set up, profile development, process implementation and operator certificate. We have been providing rework se
Electronics Forum | Fri Nov 17 15:12:26 EST 2006 | mds33200
Hi, I am located in Auburn Mass (USA) right near Worcester. Now I noticed you talked about micro stencil for a populated PCB, would I need one? Or could I use a syringe to lay a tiny dot of paste since im only replacing a chip or 2 (at the moment)? I
Electronics Forum | Fri Nov 17 14:42:06 EST 2006 | billwestiet
Mark, This is a big topic. Where are you located, it would probably be best to hook you up with someone in your area. Anyhow, lead or lead free should be based on whether the circuits are lead or lead free. I would guess that cell phones would all
Electronics Forum | Fri Dec 19 11:32:46 EST 1997 | Kris Ganev
Can anybody give me feed back on the pro and cons of using Pace, OK, Hakko, Metcal, etc... equipment in their rework processes? I need to set up a low volume rework station for mixed technology boards. Would appreciate any suggestions.
Electronics Forum | Thu Jul 12 20:58:30 EDT 2001 | davef
ERSA and PDR Xytronic both make very respectable lower priced rework equipment.
Electronics Forum | Tue Jun 15 15:10:44 EDT 2004 | mrmaint
Looking for feedback on an Airvac DRS24C Bga rework station. Looking for both good and bad feedback. Users only please, no sales folks. Thanks MRMAINT
Electronics Forum | Thu Jun 08 06:08:06 EDT 2000 | jacqueline coia
Hi There, I know this is a long shot but does anyone in Scotland have a 31mil nozzle for an Airvac rework station that they are willing to hire out for a short period of time? Also is there any papers or sites that can give good technical advice on B
Electronics Forum | Thu Aug 16 15:29:30 EDT 2001 | steven
When Air-Vac introduced an IR system at a show in San Jose, people though it was the greatest thing since sliced bread. For obvious reasons they discontinued the short life of the IR systems and implemented hot air into their rework stations. Sales
Electronics Forum | Tue Feb 05 16:06:48 EST 2013 | mlevesque
We are looking for a new BGA rework station. We got an ERSA IR550A and we are not very satisfied. I'm not sure that IR reflow is the better solution because the top-side heating is too large. I think is better with a convection "forced-air" heat.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
