Electronics Forum | Tue Apr 08 04:40:43 EDT 2008 | fnorradd
Hi, just wonder if anyone has any recommendations of where i can find spare parts for the adjustable PCB workboard holders ie, clamps, support arms and spring loaded supports etc. Basically looking for everything apart from main plate. Any details
Electronics Forum | Wed Apr 09 03:21:36 EDT 2008 | fnorradd
Hi Steve, The adjustable workboard holders are a mixture of universal and aftermarket, they do not use the clamp down arms which were originally with the universal pbs holders, they are the type which have two grub screws holding the clamps to the h
Electronics Forum | Fri May 11 09:11:05 EDT 2001 | Ian T
hi all i'm looking for a automatic pcb seperator, that uses a knife not a router. i haven't been able to find one one the net. any help whould be appreciated thx ian
Electronics Forum | Fri May 11 11:17:06 EDT 2001 | caldon
www.cencorp.com They have a host of PCB shearing seperating machines. Caldon W. Driscoll ACI USA 610-362-1200 cdriscoll@aciusa.org
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Tue Mar 25 09:35:28 EDT 2014 | emeto
Have you tried to bake the boards before you process them?
Electronics Forum | Tue Mar 25 10:31:05 EDT 2014 | sara_pcb
The boards are baked for 2 hours at 120 deg C Regards, R.Saravanan
Electronics Forum | Tue Mar 25 11:25:18 EDT 2014 | horchak
The first impression I get is that the mask was applied over dirty or contaminated copper. What is the trace and land finish on the PCB? You also appear to have a wetting problem.
Electronics Forum | Tue Mar 25 08:29:33 EDT 2014 | sara_pcb
Please refer the attached jpegs, The problem is noticed after reflow soldering followed by conventional through hole soldering. Flux used one is MIL Std. Brush cleaning in IPA is followed after each soldering step. regards, R.Saravanan
Electronics Forum | Tue Mar 25 11:43:48 EDT 2014 | sara_pcb
It is Solder Mask on Bare copper, The land finish is HASL as per MIL-PRF-55110G which accepts trace of HASL as acceptable. Wetting is acceptable. regards, R.Saravanan
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)