Electronics Forum | Tue Jun 17 20:03:44 EDT 2003 | samaniegocesar
Hello Jipp. Before I recomend something, can you send to me a picture of the PCB (Bare board) and one picture with the PCB with components, I could help you. samaniegocesar@smtnet.com, samaniegocesar@hotmail.com Regards...
Electronics Forum | Tue Jun 17 13:12:57 EDT 2003 | Jipp
We designed small PCBs (typically 2"x5")for our some of our products for quite some time now. We did not use PCB extensively and just hand-produced everything but... We now use them more and more and they got more sophisticated. we're heading for 20
Electronics Forum | Tue Mar 20 15:59:15 EDT 2007 | blnorman
We use preprinted labels and laser coding. For PCB we laser mark with CO2 (NdYAG for the aluminum heat spreaders). We either have an epoxy legend to burn out or we burn the solder mask to expose the copper ground plane underneath. Laser is a much
Electronics Forum | Mon Nov 09 06:31:04 EST 2015 | rushpcbuk
Hi, I would recommend rush pcb which provide you a full turnkey pcb solution. http://www.rushpcb.com http://www.rushpcb.co.uk (Europe) This is without any doubt the best source of low cost pcb with great quality and fast delivery. Steve
Electronics Forum | Fri Nov 17 02:09:05 EST 2017 | yongrong
Dear Maxim, How is everything going? This is YourPCB Technology in Taiwan. We provide one total solution for PCB fabrication. We hope that our clients can get better and better with our service. If you have any questions, please don’t hesitate to co
Electronics Forum | Thu Jul 06 23:53:20 EDT 2017 | comortled
Hi I feel like ,I can surely help you in this matter. I too was searching for an assistance in PCB manufacturing and layout for my project work going on. I was a bit confused regarding the process,and was looking for someone for the technical suppor
Electronics Forum | Thu Oct 23 23:38:48 EDT 2008 | pathakvj
We have 8 layer HASL PCB. We saw molten solder blobs / balls on op side of assembled PCB. (to check, if this was a bare board problem), We passed bare board as received thru, SMT reflow oven and saw solder balls on top side of board. What could be th
Electronics Forum | Mon Oct 24 06:31:31 EDT 2022 | richardcargill
We have a similar board and came up with a quick and dirty solution. The board locates via pins onto a manual desk press with strategically placed feet to break the mouse bite. Not really much quicker than doing it all by hand, but after a thousand p
Electronics Forum | Tue Aug 28 09:11:26 EDT 2012 | rway
Thank you for your reply. We will try your suggestions and keep you posted.
Electronics Forum | Mon Aug 27 16:40:15 EDT 2012 | cobham1
Ran them with stiffners and I worried about moving parts also but had the stiffners cut so that they could only go on so far which made it ok because The distance from the stiffners and parts was 1/16 of an inch no problem with movement.
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
