Electronics Forum | Tue Oct 07 08:44:49 EDT 2014 | emeto
Hi, 1. I will run the board on the mesh if single sided. 2. For double sided board, I will try stiffeners. 3. If stiffeners don't work, then you have to create a handling fixture(holds the board and has enough openings to let the air flow to the PC
Electronics Forum | Mon Sep 14 18:40:39 EDT 2020 | dwl
A reflow oven with Center rail support can help. If your volumes are too low to justify spending $$ on a proper carrier, titanium stiffeners applied to the PCB before it goes into reflow is a cheap, albeit manual solution.
Electronics Forum | Thu Oct 14 23:01:48 EDT 1999 | Dennis O'Donnell
With loaded boards, warpage can be removed by placing the assembly in a wave solder conveyor pallet as you would if you were going to wave solder the assembly. Place board and fixture in a Blue M forced air oven at 90 C for 30 minutes. Let cool to r
Electronics Forum | Fri Oct 15 11:05:50 EDT 1999 | Mark Phinney
Earliar we had problems with board warpage, Much of our problem was due to imbalances in the copper on oppisite layers in brief on a 8 layer board the copper on layer 1 should = the copper on layer 8, 2=7, 3=6, 4 = 5. We added copper to some layers t
Electronics Forum | Thu Oct 14 20:42:07 EDT 1999 | Jeff Ferry
Grace, As deifned in IPC 7721 Procedure 3.2 Bow and Twist Repair "Bow and twist after soldering shall not exceed 1.5% for through hole PC boards and .75% for surface mount PC boards. The bow and twist shall not be sufficient to cause difficulties d
Electronics Forum | Mon Jan 30 05:58:39 EST 2017 | rob
Hi all, > > Am new to SMT here. > > I have a very > thin laminate substrate which around 120um > thickess. Being that thin, warpage is constantly > an issue for us. > > For the solder printing part, > we have a number of problems. > > Being s
Electronics Forum | Mon May 13 06:15:12 EDT 2019 | dhanish
how to control warpage on panelized pcb during reflow process.we are already running with pallet.Encountering problem to insert the pcb into pallet after first reflow cycle.The insertion is being done by robotic arm. Any recommendation on the profile
Electronics Forum | Thu May 23 10:21:19 EDT 2019 | emeto
What is the material of this PCB?
Electronics Forum | Mon Jul 01 04:39:49 EDT 2019 | sssamw
yes, You need tell us how the PCB and board designed, size, material, how de-paneling the PCB?
Electronics Forum | Mon May 13 23:44:26 EDT 2019 | dami0629
if use tray cannot solve the problem, you can change from the design 1）Reduce the effect of temperature on PCB 2) PCB USE HIGH TG 3) BOARD THICKNESS TOO THIN 4) MODIFY THE BOARD SIZE 5) Reduce the V-CUT depth.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
