Electronics Forum | Wed Jan 03 14:28:09 EST 2018 | horchak
Well said mark. Btw anybody know a good tree trimmer?
Electronics Forum | Thu Dec 20 03:07:56 EST 2018 | robl
Hi Bob, I've always found Silky to make great tree trimmers - http://www.silkysaws.com probably a bit too risky to trim anything smaller or bushier though. Just need to get myself a Silky franchise now....
Electronics Forum | Mon Dec 11 19:04:06 EST 2023 | SMTA-64387074
Looking for information on lead trimming after wave solder. Does anyone do this through automated equipment? I know ideally parts would be cut to length before insertion and not trimmed after wave solder but sometimes that is cost prohibitive. When n
Electronics Forum | Thu Jul 20 17:03:09 EDT 2000 | Darby
Ketan, If you are using a z-axis head, pay very careful attention to the pick up height so that you don't force the head into the component. Also pay very careful attention to the placement height, we set the component height to 0.05 to 0.1mm over th
Electronics Forum | Tue Jan 30 21:15:51 EST 2001 | davef
You seem to pretty far from shore to begin thinking about boats and floatation devices. Most laser trimmers are used by: * Semiconductor fabricators * Resistive component fabricators * Hybrid circuit assemblers Component fabricators and hybrid [
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)