Electronics Forum | Wed May 02 23:52:12 EDT 2007 | paligora
After a battery backup failure, I have lost the software from a PCB unloader. This is a Tamura brand magazine unloader using an omron PLC. I'm not sure this forum accepts pictures. I am told that if I can find someone with the same hardware and so
Electronics Forum | Fri Apr 09 15:52:57 EDT 2021 | daniellongo
The MPM Accuflex will unload the PCB to the conveyor when an explicit button command is given in Configure/Product transfer/FMI/Advanced/"Unload" or if there is a stretch error and the operator is given the choice to "Unload PCB",
Electronics Forum | Wed Jan 09 06:37:04 EST 2002 | renocassar
I was contacted in order to set up a factory in order to produce home and car alarms equipment. I wish to use a fully automatic SMT line. That is I want a pcb unloader, glue dispenser, conveyers, Pick and Place machine and unloader. The maximum board
Electronics Forum | Wed Sep 01 16:33:33 EDT 2010 | smellew
Mike, I don't know this loader, but if you link 3&4 locally on the downstream conveyor, this should make it request PCB from loader via 1 & 2 PCB should then unload.
Electronics Forum | Tue Aug 12 19:18:34 EDT 2008 | arminski
Hi davef, couple of questions: clarifying costing of direct labor against overhead cost: an operator loading PCB onto the reflow oven is a direct cost, how about the reflow process time of the PCB while travelling inside the reflow, is that an ove
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Thu Apr 30 01:08:52 EDT 2009 | smtmen
Anybody know how to solve this problem, i have buy one machine panasert HD3C glue dispenser. But during Auto Mode PCB cannot transfer in, there is no loading unloading sensor and make me confuse. Does anybody have wiring diagram for this machine.
Electronics Forum | Mon Apr 24 11:44:53 EDT 2017 | emeto
It is good to have: conveyor after SPI(if you don't have SPI should be after the printer), conveyor before the oven(inspection station is better), conveyor after the oven - before your destacker if you have one. The rest of it, depends on how long li
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
DONGGUAN KINGSUN AUTOMATION TECHNOLOGY CO.,LTD is a company which mainly provide used and new SMT parts, provide repair SMT key parts service,new/used SMT machine trading,SMT consumables and Peripherals equipment,Clean room, ESD..
3th, Tangchang 3rd Road, Hengli, Dongguan City
Dongguan, 30 China
Phone: 8615629932323
winsouce.jpg)
.gif)
