Electronics Forum | Wed Feb 20 09:05:38 EST 2008 | tonyamenson
We had a similar problem with lead-free through-hole components. We baked those baords to remove the residual moisture and everything went to 100% pass - defect was gone. Couldnt hurt to try a sample run while you decide if the PCB holes need to be
Electronics Forum | Fri Mar 02 08:52:20 EST 2001 | markkrmp
Are your voids looking like blow holes also? Is this only occurring on the solder joints of the Thru Hole components and Via's? Or does this happen on SMD pads? My experience is that we have seen this but only with some of our older PCB's which are
Electronics Forum | Sat Aug 18 11:23:10 EDT 2007 | Learn From U
Hi All, Via X-rays, we found solder voids appear on PTH location, especially on Dimm connectors area. We think this should be related to PCB issue as we found solder unable to fill up the PTH hole during bare board testing at wave soldering machi
Electronics Forum | Tue Feb 19 23:00:29 EST 2008 | amarpreet41
Connector pin - 10.83 mils Hole dia - 27 - 33 mils. We are trying to find the optimam level for hole dia.
Electronics Forum | Tue Feb 19 22:50:00 EST 2008 | amarpreet41
Do you of reducing hole size of DIMM connector will improve solder voids??
Electronics Forum | Tue Feb 19 22:57:38 EST 2008 | davef
Duno. What's the diameter of: * Finished connector lead * Finished through hole We reckon: Lead size plus ~0.25mm [0.010"] is normal.
Electronics Forum | Wed Feb 20 09:29:19 EST 2008 | mun4o
ni, I had similar problem too.I bake PCB in SW mashine - about 8h ,T=90 C.Problem is in the base material of PCB - there are moisture in the material.After my complaint to PCB factory , they change material and the problem disappear.
Electronics Forum | Sun Aug 19 15:34:20 EDT 2007 | davef
What are you trying to do: * Improve hole fill? * Reduce PTH voiding? Hole fill: Search the fine SMTnet Archives for stuff like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=36063 PTH voiding: Ideally, there are no voids. We're unawar
Electronics Forum | Thu Feb 21 04:41:37 EST 2008 | mun4o
hi,Toni, we use only FR4.Some of PCB we order in China and Taiwan.With these PCBs we can't any problem.Other PCB we order here in Bulgaria.The problems with voids start last year - we have voids only in PCBs from Bulgarian factory.The process is sam
Electronics Forum | Wed May 06 04:31:42 EDT 2009 | radzi
We have prob Solder voids for Connector, Micro D. We used HMP solder wire and pcb thickness is 0.093".
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830