Electronics Forum | Thu Aug 09 07:53:16 EDT 2012 | davef
Allowable bow & twist: Together, both IPC-A-600G and IPC-6012B represent the core IPC documents for describing the acceptable and nonconforming conditions that are either externally or internally visible on finished printed boards. IPC-A-600G relies
Electronics Forum | Mon Aug 18 09:28:04 EDT 2008 | eyalg
The following standard is used to determine warpage: "High Temperature Package Warpage Measurement Methodology" JESD22B112
Electronics Forum | Mon Mar 03 10:31:57 EST 2003 | Tim Nicholson
Is there any standards for board warpage for surface mount boards?
Electronics Forum | Sun Aug 24 08:57:56 EDT 2008 | davef
For an nate measurement method, look here http://www.ipc.org/4.0_Knowledge/4.1_Standards/test/2.4.22c.pdf For bare boards, look to IPC-6012, par. 3.4.4 For assemblies, look to IPC-A-610
Electronics Forum | Thu Oct 14 04:28:29 EDT 1999 | Grace Chua
Hi there, I have quite a number of problematic bd due to warpage problem. I would like to know the method on how to measure PCB warpage, thus to decide on the dispositon of these boards. Another question, can these warp bd be rework/fix. Is there
Electronics Forum | Tue Oct 07 03:55:03 EDT 2014 | puja
How to avoid /reduce warpage in long length PCB &
Electronics Forum | Wed Sep 02 11:41:29 EDT 2020 | pradeep14
How to reduce the PCBA warpage issue after Reflow oven for 1mm PCB Thickness
Electronics Forum | Tue Oct 07 22:15:12 EDT 2014 | padawanlinuxero
How to avoid /reduce warpage in long length PCB & > _1.6MM THICK PCB. You need to put it in a fixture or pallet to run it in the reflow oven, most common material use here is durostone for the pallets that we run in the reflow oven, we use Durosto
Electronics Forum | Thu Oct 14 18:25:29 EDT 1999 | JAX
Grace, You can get the information you need from IPC. Measuring board warpage is covered in theie 610B manual. It will let you know the what can be reworked and what cannot.
Electronics Forum | Tue Oct 07 08:44:49 EDT 2014 | emeto
Hi, 1. I will run the board on the mesh if single sided. 2. For double sided board, I will try stiffeners. 3. If stiffeners don't work, then you have to create a handling fixture(holds the board and has enough openings to let the air flow to the PC
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.png)
