Electronics Forum | Wed Jan 12 15:32:08 EST 2005 | SuePH
Thanks for the replies. I use a foam fluxor, so the pallet is well fluxed. This is my first expierence with this thick of a pallet. Maybe Russ has a handle on it when he says that the wave height is just too high.
Electronics Forum | Wed Jan 12 12:11:51 EST 2005 | Grant
Hi, Are you coating the bottom of the palette with flux? What's the material of the palette. I have not seen that, but we did have some weird problems when we did not add flux on a virgin palette, but once it dirtied up a little it was ok. We had
Electronics Forum | Thu Dec 08 22:24:48 EST 2016 | anhsang38
We are currently using wave solder pallet for our wave soldring process. I want to find a solder pallet cleaner machine that for cleaning pallet. Does anyone know where can i buy this machine. Pls, advise me for this case.
Electronics Forum | Fri Apr 13 14:51:01 EDT 2001 | Mike R.
Some Selective wave solder jig designer milled down the jig in one depth which is based on the thickest part on the bottom side of the board. This will create problem on the warpage on the jig due to the heat coming from the wave soldering machine. I
Electronics Forum | Mon Jul 17 23:15:18 EDT 2017 | ivyzhang
Hello sir , our SM-8400N wave solder pallets cleaning machine is your best solution, Fully automatic with Washing -rinsing -drying process. For machine details ,please email me :assistant@china-sam.com .
Electronics Forum | Fri Apr 13 19:38:28 EDT 2001 | Mike R.
I'm in Anaheim Area, if any body needs help for SMT Carrier Plate, Print Plate, Solder wave jig/Pallet and Assembly jig, Please send me an e-mail. miker228@cs.com
Electronics Forum | Mon Apr 09 07:12:17 EDT 2001 | Reg
I was wondering if anyone could advise me as to the thickness of a selective jig for wave solder. We currently run with a difference of ~6.7mm from the base of the jig to the base of card which to me seems too deep but this is what our jig manufactur
Electronics Forum | Tue Apr 10 10:10:03 EDT 2001 | Rob Fischer
Obviously the less mass in the wave the better. There will be less heat sinking and less push on the solder. Pallet thickness is typically a function of the tallest component on the board. If the board has one component that is tall but small in a
Electronics Forum | Fri Jul 09 06:51:46 EDT 2010 | cobar
Try titanium edge stiffners on the PCB before making solder pallets.
Electronics Forum | Fri Jun 25 13:56:01 EDT 2010 | tate350
Consider using wavesolder pallets that keep the board flat during wave. Keep the board in the pallet after wave until it cools down a bit then remove it.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
.gif)
