Electronics Forum | Tue Apr 24 15:25:11 EDT 2012 | davef
Capacitors in parallel add. Look here ... http://hyperphysics.phy-astr.gsu.edu/hbase/electric/capac.html
Electronics Forum | Wed Aug 28 03:16:14 EDT 2002 | bentzen
Hi. I have a huge problem with Fuji CP643 recognition of 0603 (1608) capacitors from PhyComp. The terminations appear round with no clear corner edges. I have used vision type 10 but also tried others without luck. For certain parts I have 10 - 20 %
Electronics Forum | Thu Aug 16 19:54:12 EDT 2001 | davef
Understanding Temperature Coefficient of Resistance * http://www.riedon.com/temp_coeff_nt.htm * http://hyperphysics.phy-astr.gsu.edu/hbase/electric/restmp.html * http://www.rit.edu/~674www/programs/phys273/temp_coeff.html
Electronics Forum | Wed Oct 20 07:42:24 EDT 2004 | rlackey
Hi Arman, There are a number of sites dealing with the Corona Effect all with different slants in how it applies to them (Astonomers, physicists, Radio enthusiasts, etc.), but the basic definition I remember from my physics lessons at school is as f
Electronics Forum | Fri Sep 20 05:17:10 EDT 2002 | byates
What are the error codes?? you dont even know if it is the vision type until you have checked this out. It could be camera lighting. Do you know how to use vision trace on your machine? What is your x&y tolerance? What about vision 254 or 255 have yo
Electronics Forum | Wed Sep 11 01:17:59 EDT 2002 | Brian Sloth Bentzen
Hi Steve. My Fuji CP6 is model 643 and are 3 years old, maintained and upgraded with the newest software along the way. And, actually it was Fuji Japan that gave in, not Fuji America. Fuji Japan tested our components and found the same problem and
Electronics Forum | Tue Sep 10 23:37:22 EDT 2002 | Steve E
Dear Sir I can assure you that I have personal experience with the part in question.This part will run with the recommend vision types ( 11 & 12 ). I noticed You neglected to state how old the machine was, and the amount of hours. The CP-6 series hav
Electronics Forum | Fri Sep 20 20:03:55 EDT 2002 | mjabure
Well chip I ought to leave you guys hanging in the breeze on this one , but here goes. Steve, your assumption that the nozzle is calculated as part of the component body for types 11 & 12 is incorrect. during center test on the 643's one of the par
| 1 |
.gif)
winsouce.jpg)