Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Sat Mar 26 14:21:01 EST 2005 | andras
My CSM pop-ups this error after power on: 243 X DRIFT ADJUSTMENT NO GOOD and then latch-up. How can I solve this problem?
Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine
We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our
Electronics Forum | Tue Jun 09 04:48:13 EDT 2015 | vinitverma
What axis does it show in the error?
Electronics Forum | Mon May 18 10:41:46 EDT 2015 | leeg
Over Current is normally when something is jammed.
Electronics Forum | Fri May 15 18:12:30 EDT 2015 | raynewing
I have 2x machines which display this error code. Any help would be greatly appreciated.
Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Tue Jun 17 10:46:16 EDT 2014 | bestglobalsmt
When the machine loads up it gets to the 2nd to last step where it starts to load vacuum data - we get 4 pop up windows once that fails. Ea2510 Machine Start error - Machine cannot be started Es00212 APPL CPU Haandshake error Ea2504 I/O Data trans
Electronics Forum | Thu Sep 30 17:10:36 EDT 2010 | jeremie
You would still need a valid PDC (Product Delivery Code), only obtainable from Philips/Assembleon, to enable the software regardless. Unless you still have these codes the software will be useless to you.
Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
.gif)
