Electronics Forum | Thu Sep 24 06:48:55 EDT 2015 | tercel
Thank you for the fast response and help! Machine runs fine again!
Electronics Forum | Wed Sep 23 08:29:19 EDT 2015 | tercel
Hi, I read about the problem "243 x drift adjustment no good" on a Philips CSM 60 (my type) and other machines of this type. I have the same problem but no manual for the machine to solve it. Do you still have the manual where the "Drift ajustment" i
Electronics Forum | Thu Sep 24 06:50:47 EDT 2015 | tercel
btw: Pots are VR16(x) and VR 17(y) on the left board and VR17(r) on the right board.
Electronics Forum | Thu Sep 24 07:07:44 EDT 2015 | ermani9
Great News!! Happy to hear!! Yes. Location of these ports vary for different Models of control cards of machine.
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Thu Aug 04 21:20:50 EDT 2011 | jeffr
Is that Philips CSM60 ? (Old Yamaha machine)
Electronics Forum | Thu Nov 28 11:23:35 EST 2019 | csm
Dear All I would like to know your opinion and comments about Universal GC-60D performance to mount high volume for component 0402's, do you recommend this machine? we are working to get one GC-60D or the Panasonic CM402 machine. I just have exper
Electronics Forum | Fri Nov 29 14:45:36 EST 2019 | csm
Dear Alexey I appreciatte your comments and suggestions, we have some old machines and we will replace some of them but unfortunatelly budget is limited. We say videos where we can see the GC-60D working and it looks good. Regards
Electronics Forum | Fri Jun 16 07:58:22 EDT 2000 | Wolfgang Busko
What�s your problem ? Wolfgang