Electronics Forum | Thu Jul 29 01:01:11 EDT 1999 | DLKearns
| Dear all | Please help me to know what kind of tests usually done after SMT Pick & place and reflow oven. | Our appliocation is Mainly fabrication of mother boards. | Thanks | Hunter, YES ICT after SMT reflow is expensive, we currently onlt t
Electronics Forum | Thu Feb 15 15:14:20 EST 2018 | dleeper
How are you shipping, 3rd party such as UPS, DHL, etc. Or do you have your own personnel who will be a lot more carful with the packages? I've shipped boards just in the silver ESD bags with out problems. The trick is to pack them fairly tightly so
Electronics Forum | Fri Sep 09 05:27:41 EDT 2016 | jasltd
Bud, hard to say without looking at bom / drawings & what manning you have avaiable to figure out what you need to put in place to get the build rate you need. is the cabinate supplied as is or do you have to build that as well? You'll need some ele
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Fri Sep 11 17:02:10 EDT 2015 | adeanda74
Simon, Normally that error is caused by a bad motor but also there is a possibility that a driver board or even the servo board are defective and last but not least check all your cables and connections. finally let me mention that you can also recei
Electronics Forum | Sun Mar 06 17:10:41 EST 2005 | Darby
The manual gives you a fair idea here. Reference for the Yamaha manual is THE6006 - I don't know if Philips is the same. Cause is either overload or overcurrent. The manual suggests that you can tweak the trimmers on the driver board but these are us
Electronics Forum | Fri Oct 18 21:42:04 EDT 2002 | caldon
We did weekly and monthly. Final assembly (Heavy use) recieved weekly. Field service area, sub assembly, low volume, ..... we went monthly. I wrote the ISO specs to read "Calbration of screw drivers to be monitored and logged"( this Simplified of
Electronics Forum | Mon Jul 06 22:17:13 EDT 2009 | emanuel
Thanks Jeff, I isolated the problem to the DC servo part. The GD3 signal in the safety circuit chain is the one that generates this L004 Feedback Error - which by the way next to it I get also (Wn) where n is changing form 1 to 3 every time I push r
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Thu Jun 01 16:46:40 EDT 2023 | assuredtech
We have the following Samsung CP20 spare parts and feeders available, we also have CP40 - CP45 spare parts and feeders available - please inquire. 1.) Fine Suntronix MRK OR4-H Power Supply 24V 16 Amp Output 2.) Y Axis Service AmplifierSanyo Denki PY0
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155