Electronics Forum | Tue May 24 05:52:09 EDT 2016 | nikkilouie
Hi everybody, right now we are having a second hand machine of philips. the topaz and eclipse and unfortunately it dont have any manuals and no one from our team knows that machines. so im looking for anyone could give any user, programming and parts
Electronics Forum | Wed May 25 07:20:26 EDT 2016 | jasper
Dear Sir, We have the complete original manuals for you from our stock. Please send me your company name, your name, address, email and I will organise the manuals for you. Jasper (EUROPE-SMT, your no. 1 Assembleon specialist worldwide) jvanmeerten
Electronics Forum | Thu Nov 24 16:41:10 EST 2011 | captcaveman
just purchased Philips Comet, Orion and Eclipse machines and I was wondering if there was anywhere i could get the manuals for them? Any help is very appreciated...
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Fri May 14 11:14:57 EDT 2010 | thanh
wow, no one can figure out why it doing that????
Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Wed May 05 16:12:30 EDT 2010 | thanh
after calibration, now i'm having an issue that placement between lazer and camera off about .5mm on the Y mount. if parts go to camera, the placement are good. but parts that placing with lazer it off about .5mm at Y for all rotation. anyone seen t
Electronics Forum | Tue Jun 01 15:06:40 EDT 2010 | thanh
I did. Nothing change. I can go in mount feed back and increase .5mm for all rotations(Lazer mount feed back), then it work. But all my parts go to camera will be off the oposite way.
Electronics Forum | Sat May 29 02:20:08 EDT 2010 | vinitverma
Mch Adjust > Adjust Target > Laser Unit > Nozzle Position. Here the laser will automatically detect the centre of the nozzle. Remember - It'll give you the option of using a component for the test but DON'T use any component. Let it detect the centre
Electronics Forum | Wed Nov 21 13:42:12 EST 2007 | etienne
To answer your question: During my experience with Topaz machines, we had to replace 4 Heads on different occassions with different operators involved. Also I encountered several Head crashes with Eclipse machines. To buy such replacements here in Ma
