Electronics Forum: philips orion error codes (Page 1 of 2)

Philips CSM66/II error code

Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby

The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know

Philips CSM66/II error code

Electronics Forum | Sat Mar 26 14:21:01 EST 2005 | andras

My CSM pop-ups this error after power on: 243 X DRIFT ADJUSTMENT NO GOOD and then latch-up. How can I solve this problem?

Yamaha CSM84VZ error code 79

Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine

We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our

Yamaha Philips TOPAZ error code L007 OVER Current

Electronics Forum | Tue Jun 09 04:48:13 EDT 2015 | vinitverma

What axis does it show in the error?

Yamaha Philips TOPAZ error code L007 OVER Current

Electronics Forum | Mon May 18 10:41:46 EDT 2015 | leeg

Over Current is normally when something is jammed.

Yamaha Philips TOPAZ error code L007 OVER Current

Electronics Forum | Fri May 15 18:12:30 EDT 2015 | raynewing

I have 2x machines which display this error code. Any help would be greatly appreciated.

Philips Orion 2 Error Message

Electronics Forum | Wed May 02 22:14:21 EDT 2007 | DSD

The Philips Orion (Yamaha YV100) Head I/O Board is usually at fault as this tends to suffer trackwork problems with age due to the constant flexing of the board stressing the connectors on the board, thus breaking tracks within layers. You should not

Philips Orion showing a L049 motor error.

Electronics Forum | Fri Sep 11 12:44:16 EDT 2015 | simons

Our Philips Orion shows a L049 motor error immediately after we turn it on. Note that the Y axis servomotor was very hot prior to the last shutdown. Is this a problem with the motor or one of the boards?

Philips Orion showing a L049 motor error.

Electronics Forum | Fri Sep 11 17:51:55 EDT 2015 | simons

Thanks Armando. What is the easiest way to check if the motor is bad?

Philips Orion 2 Error Message

Electronics Forum | Wed May 02 09:14:08 EDT 2007 | stefi

Hi, We have a very annoying problem with a Philips Orion 2 SMT machine. It displays the error message "Second Limit Over" a few times per shift and it's impossible to make the machine work again unless it is turned off from the mains. It stops in th

  1 2 Next

philips orion error codes searches for Companies, Equipment, Machines, Suppliers & Information

ORION Industries
ORION Industries

ORION provides innovative solutions to our customers' EMI/RFI Shielding, Insulating, Screening and Sealing needs in a broad spectrum of manufacturing environments.

Manufacturer / Distributor / Consultant / Service Provider

1 Orion Park Drive
Ayer, MA USA

Phone: 978-772-6000