Electronics Forum | Mon Aug 06 13:17:31 EDT 2012 | leemeyer
Contact Sipad Systems and see if your board is a match for their process. They use a flux that stays tacky for weeks. We have used them in the past for exactly this reason and everything worked out well.
Electronics Forum | Thu May 23 12:27:53 EDT 2002 | johnw
yngwie, are you getting a wave from the customer to say it's not your fault you fried the parts? Profiling's one of those things that is a pain to dobut it's one of the most important factors in the assembly processes. I've read and seen instances w
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Wed May 22 16:36:13 EDT 2002 | slthomas
What methods do you guys use for maintaining lot and/or board traceability? When I worked in med. products, we used travelers that we recorded everything on, then serialized them at the end of the build. Not as effective as up front serialization,
Electronics Forum | Tue Feb 26 15:20:12 EST 2008 | schorschimi
The german machines use the same basic procedure as the Compact Systems CS-400E but (to my knowledge) no cut and clinch. Can you give any information about manual visual inspection after stuffing boards with such machine. If stuffing boards without
Electronics Forum | Thu May 21 11:39:21 EDT 1998 | Brian L. Pollitt
| We are looking to bring in a HP 5DX System. This is | the laminography equipment formerly known as Four Pi. | I have our sales rep getting us a few references, but I | wanted to get some opinions from the tech net. | I am looking for input from
Electronics Forum | Wed Jun 02 09:50:00 EDT 1999 | Earl Moon
| Hello all | I have a question concerning whether or not there is any special requirements to follow for assembly of a Polyimide PCB card. The customer has the following information on there documentation but since we have never built anything with
Electronics Forum | Thu Jul 26 13:08:59 EDT 2007 | Mike Konrad
The best method of cleaning misprinted boards is with a stencil cleaner. I would not recommend the use of a spray-in-air system for misprints. Spray systems can cause solder paste to become embedded into vias and under components (if double sided).
Electronics Forum | Mon Nov 12 16:14:47 EST 2001 | davef
Yes!!! How can we assemble boards with 20 pitch when we allow 0.008� error to the master art? Excellent question!!! IPC-D-300G has nothing to do with assembler requirements. It is written by and for fabricators, so that they can be comfortable.
Electronics Forum | Tue May 21 15:37:36 EDT 2013 | armelinda
I am looking for a service providing non contact PCB flatness measurement for open board SiP assembly. It was returned for failure analysis with complaint that assembly does not solder properly onto customer system board. Since there are remnants o
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
winsouce.jpg)