Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Tue Jun 09 04:48:13 EDT 2015 | vinitverma
What axis does it show in the error?
Electronics Forum | Mon May 18 10:41:46 EDT 2015 | leeg
Over Current is normally when something is jammed.
Electronics Forum | Fri May 15 18:12:30 EDT 2015 | raynewing
I have 2x machines which display this error code. Any help would be greatly appreciated.
Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Tue Jun 17 10:46:16 EDT 2014 | bestglobalsmt
When the machine loads up it gets to the 2nd to last step where it starts to load vacuum data - we get 4 pop up windows once that fails. Ea2510 Machine Start error - Machine cannot be started Es00212 APPL CPU Haandshake error Ea2504 I/O Data trans
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Fri Aug 10 16:50:20 EDT 2007 | slthomas
Yeah, we've tried that and keep getting an error stating that an impossible location has been specified (can't remember the actually wording). Right now we just move them to the back and change the feeder assignments but it definitely hoses up the op