Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
Electronics Forum | Mon Mar 11 13:27:56 EDT 2013 | ngineer
Bobpan, I have found the same, although this issue is different. If go to one of those lines in CC, and delete it, then replace it with a pick 9, then save it, i go back to the pick table, and it shows the same lead inspection electrical test, et
1 |