Electronics Forum | Mon Mar 06 11:13:08 EST 2006 | fredericksr
I ran this same process by MyData when I was there for training and I received the message that calibrating the force sensor through the service menu was an invalid technique. Correct me if I am wrong, but every tool should recalibrate itself when i
Electronics Forum | Wed Jun 06 13:33:18 EDT 2012 | upguy
As in a previous thread, we have the A12 tool tip on our TP9-UFP get sliced/damaged at random times while picking parts. Sometimes it doesn't happen for several weeks, but sometimes twice in a day. There are enough locations for the magazines neede
Electronics Forum | Thu Jul 19 04:23:38 EDT 2007 | chrispy1963
You dont mention if it is ONLY occuring with the A12 or is it other tools as well? Only spring tools or Stiff ones? Regardless of that, the small X Wagon motor is controlled by the track ball and the bigger X Axis motor is controlled by the joystic
Electronics Forum | Tue Jul 17 11:15:05 EDT 2007 | allgood
We keep seeing a problem with the plastic tool tip on an A12 tool being sliced off. I think it is hitting the edge of the tape separator clip assembly - I determined this by coating the tip in paint and then finding where the tip had struck the meta
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Oct 24 00:36:59 EDT 2018 | filipblad
I've checked the locks in the service program and the solenoids move when told to.. also I can see them opening when going to pick up a tool..
Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
