Electronics Forum | Sat Nov 25 21:26:55 EST 2006 | callckq
Dear all, I have an issue here where we found BGA crack. Understand from friend, we need to study any possiblity of our own jig or fixture cause this problem via strain gauge measurement..My question: Is there any standard @ specification establish
Electronics Forum | Wed Nov 29 01:12:12 EST 2006 | callckq
Dear Davef, Thanks for your input...The crack happen at the pad/solder ball interface..Pls review the new thread that I post just now with title called "BGA BALL CRACK AT PAD/SOLDER BALL INTERFACE" Thanks!
Electronics Forum | Mon Nov 27 08:05:50 EST 2006 | davef
There is no standard for a strain gage measurement of allowable deflection of a board or a fixture. It's possible that your fixture is causing the BGA cracking that you see. What protion of the BGA is cracking? If it is the solder connection, sear
Electronics Forum | Sun Mar 28 18:49:36 EDT 2021 | mekmat544
Hello, I would like to ask you if there is some formula how to calculate PTH hole and annual ring for pin in paste technology? Thank you. Mekmat.
Electronics Forum | Thu Jun 10 19:10:05 EDT 2021 | kojotssss
Hi, Get your account. https://software.indium.com/stencil-coach/pin-in-paste-apertures.php
Electronics Forum | Sat Jul 19 12:22:55 EDT 2008 | operator
Are there any softwares OR functions inside of the softwares that allow a designer that is creating a very large complicated wiring diagram with say....many terminal blocks and connectors etc... to run a point to point check on his drawing? Bascially
Electronics Forum | Mon Mar 28 19:58:26 EST 2005 | davef
We agree with Ken. What does your field meter tell you? Taking it a step further [erzit backward?], what is it about the measurement that requires the granite surface? Wouldn't an ESD protected bench top be as flat as needed for most gauging like
Electronics Forum | Mon Mar 17 03:50:12 EDT 2008 | Sean
Hi All, Besides the above question, I have another one as below: (1) How frequent that we need to perform strain gauge study on ICT, Functional test fixture? Is it a necessary to perform this study each time after ICT, Funtional test fixture preve
Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford
We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
.gif)
