Electronics Forum | Wed Sep 23 15:13:43 EDT 1998 | Dave
| Can anyone point me in the right direction for information on this subject, my understanding is that it is a new technique, not in widespread use yet. We have a dedicated group that has researched pin in paste and has produced a CD-rom. If you wo
Electronics Forum | Thu Sep 03 11:50:45 EDT 1998 | Dave F
| Does anyone know where I can get some 28pin SOJ Thru-hole sockets. I have the surface mount type, but need the thru-hole. | Thanks | ger@mpl.ucsd.edu Gerald: Try the following suppliers for products to convert between package styles. Dave F Aries
Electronics Forum | Mon Aug 03 13:51:41 EDT 1998 | Ted Nicholas
I am looking for some design guidelines (length, width, spacing) for solder thieves which are placed behind trailing pins of wave soldered SOICs. I'd appreciate it if some one could direct me to the appropropriate reference. Also, has any one perform
Electronics Forum | Tue Jun 30 07:23:47 EDT 1998 | Marjan
I would be very grateful if someone could provide me with recent figures (schemes)of 1. pin through hole assembly 2. hybrid circuit 3. surface mount technology. Or could anyone tell me where I can find such information? Thanks a lot. Marjan.
Electronics Forum | Tue Jun 02 08:48:06 EDT 1998 | Mike Moninger
This occurs on only one, two, or three sides at random. But I'll bet that the "good" sides have the same problem ,it's just that the center pins of the array are centered and it gets progressively worse towards each end, just not bad enough to be r
Electronics Forum | Mon Jun 01 19:41:03 EDT 1998 | Steve Gregory
(snip)...The solder is on the pads and the part is aligned to the pads with in 10% before going into the IR oven. Our problem is when the board comes out of the oven we have a strange skewing problem that I have never seen before. The part is not tw
Electronics Forum | Tue May 26 22:13:15 EDT 1998 | Pat Copeland
R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommende
Electronics Forum | Mon May 11 16:09:07 EDT 1998 | Todd N
We are having continuous bridging problems with the trailing leads on a 26-pin D-sub through-hole connector. The pitch is 0.100". The connector is going through the wave at approximately a 20 Degree angle. Does anyone have any board layout recommend
Electronics Forum | Tue Apr 14 15:50:45 EDT 1998 | Bob Barr
Justin, Thanks for the response to my dilemma. For once it's not just me! The parts seem perfectly solderable, but I will try the modification to the profile you suggested. I wonder if the retention clips may be letting loose from the holes they a
Electronics Forum | Fri Jan 16 13:41:53 EST 1998 | Luchezar Georgiev
Is there any way to implement SMT at home? I want to assemble a prototype board of mine. How can I hand-solder a 208-pin 0.5 mm lead pitch PQFP -- lead-by-lead (the usual way), or side-by-side (partial heating method)? Alas, no SMD rework equipment a
