Electronics Forum | Tue May 26 14:39:40 EDT 2009 | boloxis
QFN or MLFs are mainstream now, QFNs already evloved to much more complex versions now like matrix pins, stacked dice and flipchip versions. IPC 610D already includes them, just make sure the pins have solder plating, the PWB pads have soldermask in
Electronics Forum | Fri Jun 19 07:28:56 EDT 2009 | mhunter
Thank you for your responses Davef and Boardhouse. The material used is Iteq Corporation IT-180. I performed more testing yesterday and found the following: I could insert Berg Pins into the assembly at various locations or a Pem. None of these
Electronics Forum | Fri Aug 07 07:55:30 EDT 2009 | robhs
Hi. We are planning a production run of a board that utilises the SEMTECH SLP2710P8 8-pin device (2.7 x 1.0 x 0.58mm). The part orientation on the board necessitates that the squeegee print direction approaches the stencil apertures on the long side
Electronics Forum | Thu Mar 11 02:56:01 EST 2010 | grahamcooper22
Hi, blow holes / pin holes / holes in joints are usually a sign that there is excess moisture somewhere around the solder joint. Moisture can be in pcbs / components, so try drying them....a simple thing to do is pass a bare pcb throught your reflow
Electronics Forum | Fri Nov 18 12:35:15 EST 2011 | rway
As the article eludes to, you still need probe access to measure the pins with TestJet. One thing I wanted to add was the use of JTAG for use with Boundary Scan. Certain devices have JTAG capability, but not all JTAG devices are Boundary Scan compa
Electronics Forum | Thu Sep 02 20:41:03 EDT 2010 | mmccance
SME, Thanks for your response, but I have already checked out 1 & 2 on the downstream conveyor, and they are sending the machine ready signal. I know that the loader is recieving it because when the downstream conveyor is not busy the loader attemp
Electronics Forum | Thu Nov 04 19:55:49 EDT 2010 | eadthem
The best method i have for the few lifted/bent lead issues we have is i use a ic/bridge inspector with all its default options to check for bridges and solder at the tip. then i add a solder inspector but this time accrost all pins at the downslope o
Electronics Forum | Tue Jun 07 20:56:47 EDT 2011 | aoiguy
Any and all input will be greatly appreciated. So here it goes. I'm having an issue where the cad I'm getting from customers is referencing pin 1 as the parts placement. This isn't an issue for surface mount, however the aoi machine that we have in
Electronics Forum | Thu Sep 15 21:25:43 EDT 2011 | darby
G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say the pin width is 0.2mm and the pad design ha
Electronics Forum | Thu Sep 15 21:36:52 EDT 2011 | darby
I also posted this in the design section... G'day folks - haven't been around for some time but still soldering on. Question for y'all. One of my design engineers has shown me a Creative PCI audio card with a TQFP48 attached. 0.4mm pitch. Let's say