Electronics Forum | Thu Dec 18 15:48:25 EST 2003 | Subhash Nariani
Hello, Does anyone have experience with the PCB assembly of 0.5mm pitch chip scale packages with HASL finish? Characterization data that you can share? Tribal knowledge has it that the height variations of the solder prevent the use of HASL for fin
Electronics Forum | Fri Dec 19 09:57:07 EST 2003 | davef
We agree with Deano. Can you use ENIG on your board?
Electronics Forum | Thu Dec 18 23:44:53 EST 2003 | Dean
...don't expect high yields with hasl on that device. Yeah, you an do it. But not reliably. Also, factor in board warp, bump tolerance AND HASL variation....recipe for disaster. can your process toleate a selective gold on the one device? How ab
Electronics Forum | Wed Apr 20 10:09:20 EDT 2011 | accessguy
I have a simple battery powered led array pcb that is turned on and off via rf remote. I want to modify it so that it turns off after 90 seconds, and it flashes or blinks every second or so during those ninety seconds. Can anyone suggest a forum or w
Electronics Forum | Tue Apr 09 16:19:37 EDT 2002 | Peter L.
Has anyone built using the ALIVH PCB (0402, 0.8mm pitch uBGA) on the SMT line? I would like to know any process issues (paste printing, p&p, reflow) related to processing this pcb. Specifically, what type of solder paste was used (no clean) and wha
Electronics Forum | Wed Jan 08 14:18:34 EST 2003 | soupatech
I have run across a resistor array whose tape has a 2mm pitch. Is there a way to modify a Fuji CP3 8x4 feeder to make it 8x2? Or do I need to purchace new feeders?
Electronics Forum | Mon Jun 07 22:30:28 EDT 1999 | Dave F
| | | I was wondering what measurements are used to define pitch? | | | | | Frank: John's correct with the most common definition, but there can be others, depending on your perspective. TTYL Dave F | | | | Pitch. The center-to-center spacing b
Electronics Forum | Wed Jul 16 19:38:28 EDT 2014 | garym4569
What is the base cost of an inline pcb etcher? Specs: fiducial alignment, smema interface, 400mm x 400mm marking area. Will be used to mark panel 2d codes, pcb array 2d codes, and human readable. Thanks Gm
Electronics Forum | Wed Aug 11 18:35:17 EDT 2010 | julie1
Anyone work with or have knowledge about metal core/clad boards? The board I'm working with is approximately 2" X 3/4" aluminum core pcb, in a 56 up array. There are 3 LED placements per board. I'm having trouble getting a consistent screen print.
Electronics Forum | Thu Oct 29 18:33:18 EDT 2009 | comatose
The top picture probably won't run. You have black soldermask dramatically misregistered and overlapping what look a lot like fids. Either your machines are going to pitch a fit and not find the fid or they're going to center on the soldermask outlin
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)