7909 placed results

Electronics Forum: placed (Page 7 of 791)

Can TH component be placed on solder side of Single Side PCB?

Electronics Forum | Wed Jul 17 11:57:38 EDT 2013 | proceng1

Everything in 7.4 shows the clinch and fillet on the other side, assuming the body is mounted on the Component side. In my case, the fillet will be on the body side.

Can TH component be placed on solder side of Single Side PCB?

Electronics Forum | Wed Jul 17 12:38:50 EDT 2013 | horchak

It's what the customer wants. remember the customer is always right and that IPC is only recommended guidelines the last time I looked. I also belive IPC shows examples of PTH parts being preped and lap soldered to SMT pads so common sense says what'

Can TH component be placed on solder side of Single Side PCB?

Electronics Forum | Mon Jul 29 08:34:40 EDT 2013 | gallionc

I don't see an issue. As was mentioned before, it is what the customer wants. You could approach this from one of two ways. You could simply install the parts, clinch the leads on the opposite side for added mechanical strength and solder the parts

pick and place for 01005 components

Electronics Forum | Thu Jul 15 15:16:26 EDT 2010 | leemeyer

I am looking into pick and place machines that are spec'd to place 01005 components. Does anyone know of a inexpensive make(50 - 75K $ new) that can place these parts. So far all that I have found are 150K and up. Thanks

Pick n Place tape dot

Electronics Forum | Tue Aug 12 11:17:19 EDT 2014 | g2garyg2

This is helpful information. PROMATION just released a low cost stand alone pick and place for pre-printed labels which would also include Kapton Dots. So if you do not want to tie up your pick and place this could also be an option for placing them.