Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Wed Jul 07 10:17:33 EDT 2010 | flipit
We have this problem only with one manufacturer of LEDs. Avago LEDs give us the problems where SunLED and KingBright do not. We put a magnet under the embossed cover tape. The magnet is mounted to the feeder. Holds the part in the tape pocket. L
Electronics Forum | Mon Feb 22 10:01:01 EST 2010 | jtsyeung
Since the inductor is electro-magnetic, that means the device is composite of coil and ferrite metal. The inductor inside the reflow oven meets with blower motors which close to the inductor and generate magnetic field. With such conditions, Lawren
Electronics Forum | Fri Apr 05 11:36:48 EDT 2013 | denisp
we use panasonic mv2vb feeder q type and we place a little piece of magnet under the reel and it help a lot
Electronics Forum | Fri Nov 04 13:00:24 EST 2005 | pjc
Some clarification: Max bottom side component is not 5mm as someone posted, its 12.7mm (0.5"). This is if you're going to have a Gel-Flex block under that component. Any component height at or over 12.7mm must not have a Gel-Flex block under it. Al
Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James
They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J
Electronics Forum | Tue Dec 05 09:09:38 EST 2006 | sigmasmt
These feeders come from an old OEM plant. They had a in house system they put together so the machine will not run until you had the correct feeder in place. Once the feeder was scanned and put into the feeder slot, the magnet would help recognize t
Electronics Forum | Tue Jun 10 23:06:28 EDT 2014 | demzvill
In our assumption also, nozzle is magnetized because the chip termination is made up of alloy so possibilty that when there is excessive contact between two metals there magnetic field produce, so during z up chip is magnetize on the nozzle causing i
Electronics Forum | Thu Feb 22 11:33:24 EST 2007 | sliebl
We recently added an SPM printer to our SMT department and I need to buy some tooling pins and center supports. Other than MPM, is there any aftermarket support for this machine? Can anyone point me towards any suppliers for the above mentioned parts
Electronics Forum | Mon May 14 15:20:35 EDT 2001 | stefwitt
You can make up a plate over lapping the tape exit guide and to the right up to the nozzle changer. It should hold three standard size Jedec trays. I used the bases of two old vibratory feeder. No matter what you do, you should use strong magnets to
winsouce.jpg)