Electronics Forum | Wed Jun 29 17:56:47 EDT 2005 | Ryan
We have a new Heller 1809 EXL reflow oven and when we run MELF�s or Aluminum Electrolytic Capacitors through the oven they are being blown off the pads. I have verified that the placement is good before reflow. I verified that they are pushed down
Electronics Forum | Tue Feb 19 10:47:47 EST 2019 | rgduval
I'm with Steve. Check the datasheet, and make sure that the terminations are meant for solder application, and not conductive epoxy. I had that happen a year or so ago with an MLCC. Drove us nuts for two days (not to mention the significant rework
Electronics Forum | Mon May 02 23:42:44 EDT 2016 | ttheis
I have a strange issue where all 4 spindles of head 1 on my GSM1 are able to place small parts without a problem until the very end of the routine where a large electrolytic aluminum capacitor is placed. The part is successfully picked out of the fee
| 1 |
