Electronics Forum | Sat May 27 12:50:21 EDT 2000 | Micah Newcomb
Steve, I use homebase apertures as a standard for all chip parts and have no complaints, no solder beading, no issues. I have had to replace almost all stencils ordered previous to my arrival as they all caused defects (7-9mil thickness and 1:1
Electronics Forum | Sun May 28 08:21:52 EDT 2000 | Sal
Can't agree more than moving over to Homebase apertures, But ensure that the cut back angle is correct,to acute of and angle will leave you with an inadequate contact area fot the terminations on the chip components and you will start seeing insuffic
Electronics Forum | Fri Feb 22 09:41:54 EST 2013 | patrickbruneel
Pete, It would even be better if the wave machine manufacturers would add a feature that allows the wave to drop in rpm when a board passed the wave, and slowly get the wave back to normal rpm when a new board approaches. This would be like a reset
Electronics Forum | Thu Feb 21 10:11:36 EST 2013 | patrickbruneel
The backflow in the wave started to become very important with the development of no-clean/no residue fluxes. These fluxes don’t have (or at least shouldn’t have) rosin, resin or other vehicles in the formulation which encapsulate surface oxides from
Electronics Forum | Tue Oct 10 12:56:15 EDT 2000 | Ken Van ZIll
I agree that homplate is a good design, but also this could be caused by the stencil thickness and aperture size, if you are at 7-9 mils thick stencil and a 1:1 ratio on aperture size then 2 things i know of will happen, one a squishing out of past o
Electronics Forum | Wed Mar 21 14:12:21 EDT 2007 | mmjm_1099
fujiamerica
Electronics Forum | Thu Mar 22 09:10:04 EDT 2007 | dwarf flip (I'm actually considered a giant in my tribe)
get 'em tape and reeled and save yourself the headache!
Electronics Forum | Thu Mar 22 09:38:07 EDT 2007 | poultorp
Cyncrona A/S we make them (danish dept.)
Electronics Forum | Tue Nov 20 09:22:15 EST 2018 | dekhead
Maybe info you need?
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
.png)
