Electronics Forum | Tue Jul 29 14:25:20 EDT 2014 | kenkay
We have been struggling for a while with some through hole sealed mechanical relays that fail at test after they have been sitting a while. They will initially pass test, but seem to fail if they sit for a few days. We made sure our wave process was
Electronics Forum | Fri Apr 21 12:43:51 EDT 2000 | David
We are going to hand place through hole connectors by screening them top side in a double sided reflow board. I saw this done before sucessfully on a daily basis but is there anyone with a paper or specs as to what aperture size, any special pad cons
Electronics Forum | Tue Jan 30 01:32:24 EST 2001 | PeteC
Bill, We do solderpaste reflow on through-hole here every day on plated-thru-holes. We do it on connectors only. It is a reliable process. We use no special profile. The stencil apertures must be modified for this process. Check out the IPC-7525 "St
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Thu Feb 06 14:47:50 EST 2003 | MA/NY DDave
Hi "some customers/designers want to have via holes to be present in the PCB pad, due to some belief that it helps in heat dissipation. " As I think about this I don't know exactly why they would be concerned. I can imagine in some exotic products
Electronics Forum | Thu Oct 31 02:43:55 EDT 2013 | hqew2013
The smallest finished hole available for 2 layer board is .020”. The smallest finished hole available for 4+ layer board is .014”. All holes are round and drilled through from top to bottom layer of board. No blind or buried vias. For holes = .15
Electronics Forum | Wed Dec 17 09:53:26 EST 2003 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require. If we can�t get proper hole fill after try
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Mon Sep 28 09:35:28 EDT 1998 | Clive Heke
I have had some field failures returned recently, the boards had flux contamination under the components in a sensitive area, Nothing really visible until the component was removed, and the board had no evidence of rework of any type. Is it possib
