Electronics Forum | Thu Oct 31 02:43:55 EDT 2013 | hqew2013
The smallest finished hole available for 2 layer board is .020”. The smallest finished hole available for 4+ layer board is .014”. All holes are round and drilled through from top to bottom layer of board. No blind or buried vias. For holes = .15
Electronics Forum | Fri Apr 21 12:43:51 EDT 2000 | David
We are going to hand place through hole connectors by screening them top side in a double sided reflow board. I saw this done before sucessfully on a daily basis but is there anyone with a paper or specs as to what aperture size, any special pad cons
Electronics Forum | Tue Jan 30 01:32:24 EST 2001 | PeteC
Bill, We do solderpaste reflow on through-hole here every day on plated-thru-holes. We do it on connectors only. It is a reliable process. We use no special profile. The stencil apertures must be modified for this process. Check out the IPC-7525 "St
Electronics Forum | Wed Dec 17 09:53:26 EST 2003 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require. If we can�t get proper hole fill after try
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Fri Apr 19 13:47:00 EDT 2019 | davef
It's a terrible idea. Through holes should be drilled in the exact center of a pad +/-. Have the two holes go out back and settle this. Whichever hole returns, that hole get to keep the pad. The other hole needs to get its own pad. End of story. Th
Electronics Forum | Thu Sep 04 10:03:13 EDT 2003 | Rick B.
I'm attempting to develop paste in hole process so that I can reflow a few plated through hole components on a mixed tech board. Tried various pastes, profiles and stencil thicknesses. Would appreciate any insights and/or pointers anyone can share on
Electronics Forum | Wed Feb 05 19:43:34 EST 2003 | iman
If by the Powers Ta Be (customer/designer), you can't change the PCB design, negotiate for the PCB fab house, to block the via holes with their (green?) solder mask some customers/designers want to have via holes to be present in the PCB pad, due to
Electronics Forum | Thu Feb 05 08:39:16 EST 2004 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require.
winsouce.jpg)
