Electronics Forum | Wed Dec 17 09:53:26 EST 2003 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require. If we can�t get proper hole fill after try
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Mon Jul 06 13:17:50 EDT 1998 | Upinder Singh
| | Hi all . | | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | | I would appreciate if somebody could help me in the stated issue: | | I am trying to to place one thru hole 20 pin connector along with the SMT components by p
Electronics Forum | Tue Jun 30 18:37:19 EDT 1998 | Earl Moon
| Hi all . | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | I would appreciate if somebody could help me in the stated issue: | I am trying to to place one thru hole 20 pin connector along with the SMT components by paste pri
Electronics Forum | Tue Sep 25 14:08:59 EDT 2001 | davef
Oooo, the solder on the pad and PGA ball is flowing during reflow down the via to the secondary side? Why didn�t you say so?? ;-) Why would you expect that gravity and capillary action wouldn�t force solder to flow down the solder plated via to the
Electronics Forum | Sat Oct 30 16:53:19 EDT 1999 | jason
David I have recently taken the IPC-A-610B instructors course and according to the teacher the revised addtion is suppose to be 50 percent fill in plated thru holes
Electronics Forum | Tue Nov 02 17:52:17 EST 1999 | Dave F
Jim: Several points: 1 If you�re correct about corrosion of your component leads (which is entirely possible if the leads are steel, as you say), then the AIM 264-5 no-clean may not be aggressive enough to remove the corrosion you are seeing routin
Electronics Forum | Fri Jun 25 12:07:00 EDT 1999 | John Thorup
| | hello, | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | thanks for the input | | | | wayne | | | | | | | We have tried this mainly on thru hole connect
Electronics Forum | Fri Jun 25 16:32:45 EDT 1999 | MMurphy
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
