Electronics Forum | Fri Oct 26 13:43:54 EDT 2012 | whispell
Make sure your machine configuration is correct. You may have something assigned to the machine that is no longer there. For 24V check to make sure all of the E-stop jumpers are plugged in.
Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Sat May 26 00:32:55 EDT 2007 | crashoveride
it'll be cheaper if you'll let your wave machine up all night and let it in its idle temp (supposed to be 200��C) simply because it will need less power from idle temp up to operational temp compared to from 0�C-operational temp. Temperature Sensors
Electronics Forum | Wed Sep 25 13:39:11 EDT 2013 | bobpan
I have rarely seen a bad SRX controller card but it sounds like you may have a faulty card. Since i know you have 2 machines...i would swap them....make sure you take a picture of it or write down where all the cables plug in. The SRX board is locate
Electronics Forum | Thu Mar 23 13:36:30 EDT 2023 | tomdegas
Running a Mydata MY 9 and trying to Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command argument. It seems to be related to the x drive. I've check all the connections on
Electronics Forum | Mon Nov 01 12:32:03 EDT 2010 | jj12345
I have a question regarding the csm66, i have that particular machine - but have 2 problems : (1) Movement speed - its set at 100% but just crawls in the run mode .. i dont understand why. (2) I have a teaching camera but it does not recognize it i
Electronics Forum | Wed May 08 12:01:49 EDT 2019 | bobpan
pretty sure it does squeegie blades first....then if you have a table...it drops and starts to move out.....and then the head moves. Most times i have seen this....if nothing is moving....one of the cover switches are not made...use a magnet on each
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
