Electronics Forum | Sun Jun 04 08:49:58 EDT 2000 | Roni Haviv
Hi C.K. , You can ask your PCB manufacturer to cover all vias with solder mask from CS (It called "pluged" vias). It's done from one side to prevent any close area that can cause "eraption" of solder because of pressure under reflow. All our boards
Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Sat Mar 20 00:58:10 EST 1999 | Mike C
| After rmoving a BGA (plastic)to correct unexplained shorts | I installed another BGA using flux only. | Checking on an X Ray machine and found two shorts. | | can anyone give a good explenation ? | | Thanks | | Ron | Another possibility Via's n
Electronics Forum | Thu Aug 21 23:35:20 EDT 2003 | kennyg
For ICT purposes I may need to print solder paste on 0.015" test vias. No-clean is not an option for this assembly and OA seems the only choice. Can flux be safely removed from inside the via from the other side during a standard water wash process
Electronics Forum | Mon Mar 26 07:38:26 EDT 2007 | davef
The temperature that will melt solder holding top side SMT components during wave soldering depends on the alloy of that solder. So, for example, you'd expect: * Near eutectic SnPb solder to melt around 215*C. * LF to melt around 240*C. It's common
Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
1 |