Electronics Forum | Mon Oct 30 16:47:24 EST 2006 | SWAG
If there is a tactile sensor on this machine, make sure the switch works properly (view input test screen while pushing plunger in and out) and clean/oil the plunger.
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
Electronics Forum | Sat Feb 17 21:46:26 EST 2001 | edmo
I am the new user for siplace HS50 for about 3 months, running 24 hours production. I used to perform PM every 2 weeks. I have just changed all the plungers(Alu) and nozzles(904) and some nozzle sleeves due to components high throw-out. The estimat
Electronics Forum | Mon Jun 10 08:13:48 EDT 2013 | bobpan
Check to make sure the side covers are closed. It is probably an interlock problem. Also if you have carts...make sure the plunger switches are down. Good Luck
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Sun Feb 18 14:46:11 EST 2001 | CAL
Some key data is needed 1) how often does the HS 50 machines run? 24/7? 2)How many placements are being performed? I know for a fact Siemens Siplace S/F platforms require weekly preventative maintenance. Knowing the sophistication of the HS platform
Electronics Forum | Tue May 20 05:01:27 EDT 2003 | gavinscott
Hi, I have had this problem in the past and the best method I found was... Before removing the old syringe and fitting a new one, ensure the viton tubing is doubled over and pinched. This will help to eliminate any airlocks in the viton tubing whic
Electronics Forum | Sun Dec 14 08:26:16 EST 2003 | liang
MR/MADANM STEFAN ,WE USE A PLASTIC PLUNGE.WE REPLACE THEM THREE MONTH.WHEN PART MISSED,WE CHECK THE VACUUM ,IT IS OK. IT IS ONE OR TWO SEGMENTS WHICH CAUSE PART MISSING.WE REPLACE A PLUNGER ,IT IS NOT OK.WHEN REPLACE A SLEEVE .IT IS OK.WE CHECK THE S
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Wed Jan 30 08:27:37 EST 2019 | mst3000
Hi there. We are facing an issue with the placing head of our SMT machine SIEMENS SIPLACE CF 2004 model where the vacuum reading is low (820 instead of 900). This is resulting in that the components are either falling off when the head moves onto the
winsouce.jpg)
