Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Mon Jun 06 08:48:04 EDT 2016 | dekhead
Was it mechanical, electrical or pneumatic problem? Just curious.
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Tue Feb 09 21:00:32 EST 2021 | dekhead
Unfortunately, with the Micron ('i') series of machines, DEK seemed to stop making "ProFlow Ready" the standard on machines. In general, there are additional pneumatics and electronics required for a ProFlow installation.
Electronics Forum | Wed Aug 20 06:33:16 EDT 2008 | benefon
If this is machine is of the same type of construction as our 248 with the pneumatic table sliding mechanism, check the 'table out sensor' in the 'digital inputs' section of the diagnostics menu. rgds AR
Electronics Forum | Wed Aug 20 10:16:58 EDT 2008 | dekhead
248 Table In/Out is pneumatic (as stated), but I think Shane is referring to Print Carriage which is electrical with positional "encoder" feedback. Need to check for feedback display in output dignostic.
Electronics Forum | Mon Jan 27 10:37:14 EST 2020 | jede
In what regards? If you are wondering if the gridlock will cause damage to parts on the underside of the board, the concern is using fixed support rails. A company I used to work for fixed this by using pneumatic support rails(I am sure there are exa
winsouce.jpg)