Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Mon Sep 29 13:36:01 EDT 2014 | dustin
I came into work this morning to an error on one of my printers. After powering on machine, the error MACHINE DOWN popped up in the top left corner of the screen. I have the giant manual and could not locate a solution for this error. I have checked
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Sat May 14 13:07:42 EDT 2005 | gc
We have surge suppressors on every machine we have as well as suppression on the mains coming in the building. The power in the area has always had too much noise and we did have losses due to surges during storms and such. Three phase surge suppre
Electronics Forum | Tue May 17 11:24:52 EDT 2005 | ricardof
We don't shut the machines down, we keep them working, however,sometimes the AC supply gets down because of a storm so we have a Forced shut down, as someone said, if we shut equipment down on every storm that represents $$ millions $$. The bad thing
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict