Electronics Forum | Tue Feb 07 08:13:58 EST 2017 | fuji_user_2014
Looking for recommendations on drop ceiling busway/raceway to neaten our cabling. It is intended for a surface mount line with varying power requirements, data/com lines, and air drops.
Electronics Forum | Tue Feb 07 10:18:34 EST 2017 | swag
Our entire shop floor has a hanging uni-strut grid ceiling approx. 10 feet up. The actual ceiling of the building is probably 16 ft. max ceiling with pitch. We run all air lines and power on it. The uni-strut is hung by all-thread rods. Sounds co
Electronics Forum | Mon Apr 13 14:36:18 EDT 2009 | leemeyer
I have seen this problem before. There is a cable that runs from the Quadalign board to the backside of the backplane. It is not secured in any way so it may have come loose in shipping. Open the right side panel on the machine. The Quadalign board
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M
Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Mon Mar 11 13:02:07 EDT 2024 | denism
Hi, Did you check power cable to the camera? It is can be the reason.
Electronics Forum | Tue Jun 26 11:45:52 EDT 2007 | Frank
I certainly wasn't endorsing the use of the PVC piping that was installed prior to my employment there. Also, I recall that all the piping was above the ceiling tiles and regular air line hose was dropped along with the power cables. So there was l
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
