Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Sat Jun 17 08:57:13 EDT 2000 | Ashok Dhawan
Smtnetters One more question on ESD Control program. Does anyone ground there power equipments and how ? e.g., Pneumatic torque tools , electric screwdrivers, hand soldering stations, solder pots etc. I am not sure about pneumatic hand tools , howev
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Thu Apr 30 17:06:19 EDT 2020 | bboyer
So, I have inherited a couple of "vintage" GSM1 machines, and we've got one powered up, trying to see if it even works, before registering the machine and paying Universal some money. It appears several of the safety interlock switches are triggered
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
| 1 |
.gif)
winsouce.jpg)