Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
Electronics Forum | Wed Apr 30 11:41:55 EDT 2008 | gemengr
It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.
Electronics Forum | Mon Mar 27 12:48:12 EDT 2023 | assuredtech
Full Load Amp (FLA) ratings on a nameplate indicate that if you turned 100% of everything on all at the exact same time with the flip of a switch it would hit this FLA rating. Obviously, this would be bad and is not the reality of what happens. Each
Electronics Forum | Mon Mar 27 12:58:09 EDT 2023 | spoiltforchoice
> Full Load Amp (FLA) ratings on a nameplate > indicate that if you turned 100% of everything on > all at the exact same time with the flip of a > switch it would hit this FLA rating. Obviously, > this would be bad and is not the r
Electronics Forum | Mon Jan 06 19:12:52 EST 2020 | dekhead
If you are unable to get to Diagnostics to exit to DOS; Try the following: ‘F5’ (WHILE STARTING MS-DOS) –OR ‘CTRL’ – ‘C’ (WHILE HIMEM IS TESTING EXTENDED MEMORY) Once in DOS, CDMINT Type LOAD to download MINTS from HDD to cards. DEKHEAD
Electronics Forum | Mon Aug 19 15:21:17 EDT 2013 | marcelorotofrance
Hi Rollon, thanks for your answer. At this point it seems that cold-start current surge, because the presence of large value capacitors in the power source, exceeds the sensitivity of the protection switches rather than a malfunction. Nevertheless, i
Electronics Forum | Thu Jul 10 19:26:21 EDT 2014 | guts1872
It looks like we did have an interlock problem. Maintenance re possitioned them and it seems to have cleared up our problem. For some reason when we close the door, it still wants to reset the Amp power, but if we wait for the all clear in the GUI be
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Wed Jul 09 12:00:25 EDT 2014 | bobpan
You have a rather old machine that you are running....now realizing this you need to check some things. 1. Clean the scales in the x and y direction. On some of the encoders there is an led to see if its reading correctly....Usually it turns green b
