Electronics Forum | Wed Feb 07 08:41:10 EST 2001 | dliechti
I have to design a power supply which converts 220V AC into 5V smothed DC. It has to be very small, so it shouldn't have a big transformer. Has somebody a scheme of a circuit? Thanks
Electronics Forum | Sat Jul 24 06:00:50 EDT 2004 | zlatkon
I need to build regulated power supply 0-30V 0-20 Amps. The only solution possible for minimizing the thermal loss is to use triacs on the secondary Trafo side in order to cut the sine for low voltage output and great current. (like 5V, 20A). Please
Electronics Forum | Wed Nov 01 23:59:23 EDT 2017 | lkdhde1
F5HM power supply unit 00375503-02,consion document which I have is not suitable since this is new power supply unit, want to find out suitable document
Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Wed Feb 03 18:29:46 EST 2010 | mika
4.85 V - 5.2 Volts. That is on the computer power inlet, Not the on the power supply. /Best Regards
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Fri Mar 24 15:08:20 EDT 2023 | erikfriesen
The nameplate specs for a 2004 Heller 1088EXL show 240V 60A, and specify Largest Heater Load of 25A. As each of the 8 heater elements is 6000W or 9.5R, how does this really work? Obviously all 8 elements on would pull 200A, so does the machine only
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Wed Jul 16 14:21:15 EDT 2014 | toddp2012
Hi all, we have a Speedline Technologies ELEOCTROVERT/Aquastorm 200. In January we stared supplying it with pre-filterd to the DI cabinet next to machine so our large media would last longer. All was fine for about 4 months and then we started gett