Electronics Forum | Wed Jul 16 14:21:15 EDT 2014 | toddp2012
Hi all, we have a Speedline Technologies ELEOCTROVERT/Aquastorm 200. In January we stared supplying it with pre-filterd to the DI cabinet next to machine so our large media would last longer. All was fine for about 4 months and then we started gett
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Sep 23 15:26:30 EDT 2004 | Tarheel
Ours says Model: WD1D200KCN Input: 120 VAC 60HZ Output: 9VDC 200mA Class 2 Transformer Power Supply E31-0900-25 Electronic Control Design, Inc. Milwalkie, Oregon USA
Electronics Forum | Wed Jun 21 16:04:07 EDT 2006 | bman
"Another question, is the facility with 200A @ 208V able to operate this assembly line properly?" That could be a problem, big ovens pull a lot of juice. Our 7 zone Conceptronic HVN-102 runs on 480 Volts and is on a 160 amp breaker, for example. Y
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
Electronics Forum | Thu Aug 04 14:01:56 EDT 2022 | ttheis
We are having an issue with a Jade S200 we recently purchased. When opening the pillarcom software it is unable to establish communication with the machine. The power supplies and fuses all seem to be ok and at proper voltages. Checked as many connec
Electronics Forum | Thu Nov 20 17:30:55 EST 2014 | gregcr
Hi All, I have a customer with a very dense design (24 layers, 0201's lots of micro-BGA and lead-less), and they run extreme data rates. Every once and a while they will have a unit that has some speed fall off and they attribute that to the possib
Electronics Forum | Tue Aug 09 11:14:28 EDT 2016 | cyber_wolf
•Rated Speed of 40,000 CPH •140 - 8mm Device Locations •14" x 18" Max PCB Size PCB dimensions Max: 457mm x 356mm Min: 80mm x 60mm Board Thickness: 0.3 to 4.0mm Component capacity Up to 140 types (8mm tape) Placing rate 0.09 sec./component - 40,
Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
Electronics Forum | Fri Aug 15 16:32:51 EDT 2003 | stefwitt
Assuming you are not looking into an orchestra sound with Bose loud speakers, you can play the melody with a buzzer creating sounds like the ones from cell phones. The melody has to be stored into a programmable device, such as an EPROM. In order to
winsouce.jpg)
